subnetdoc

*FREE* How to Subnet!

My FREE "The Last How TO Subnet" PDF will show you my method of subnetting, I used this to help pass my CCNA exam. The document will show you how to quickly identify and work out class A, B and C sub-nets in 90 seconds. Don't burn the clock on your next Cisco exam with binary calculations, download my eDoc today! Then go view the video here Configure it out...

Happy New Year!

by Ron Staples on 29, December 2011

in Featured

My plans for the new year are simple, finish up my CCIE written exam and create more  content for the site.  I’m still holding off on forums simply because I’m note sure if we need another forum site.  I want to start putting out some configuration videos, mostly just me talking as I configure something [...]

{ 0 comments }

Wishing you a Merry Christmas!

by Ron Staples December 20, 2011 Featured

Father Christmas, give us some money we got no time for your silly toys Beat you up if you don’t hand it over We want your bread so don’t make us annoyed Give all the toys to the little rich boys -Father Christmas The Kinks A layer two Christmas! HAPPY HOLIDAYS!

Read the full article →

SecurCRT and GNS3 terminal setting

by Ron Staples December 19, 2011 Featured

I’ve used GNS# for a number of years, one thing that I notice is the error in the terminal settings for SecureCRT.  Granted, GNS3 does come with putty installed however I’v been  fan of SecureCRT since 2008.  This video will help you make the necessary changes  needed to allow ScureCRT 64 and 32 bit to [...]

Read the full article →

DOS commands for Network Engineers.

by Ron Staples October 27, 2011 Featured

Basic DOS commands for networking engineer’s who are interested resolving networking issues

Read the full article →

MPLS Circuit Troubleshooting

by Ron Staples October 11, 2011 Cisco Bytes

In this scenario we are asked to validate a flapping interface.  1] Find the serial interface and verify that it is up/up  attga43c3#sho ip int br | include 10.112.210.45  Serial9/1/1/20:0       10.112.210.45   YES manual up 2] Display the interface and note the errors     attga43c3#sho int s9/1/1/20:0         Serial9/1/1/20:0 is up, line protocol is up [...]

Read the full article →

Inactivity news

by Ron Staples July 23, 2011 My Blog

Just a short note to you all know what has been happening for the last three months and why there hasn’t been any new content posted to the site. It’s been a busy  three months , took the ROUTE exam , work projects then changing job roles. I recently picked up the CCIE Routing and [...]

Read the full article →

How to save your PuTTY settings

by Ron Staples May 4, 2011 My Blog
Thumbnail image for How to save your PuTTY settings

PuTTY does not write its settings to a file, for people who wish to install this on an US stick poses a challenge. When you run putty on a system that never ran it before, it will not have any of your saved settings.

Read the full article →

← Previous Entries